top of page
Writer's pictureRaven Route

An Ultimate Guide To Use Uwell Caliburn A2 Replacement Pods



The Uwell Caliburn A2 Replacement Pods are refillable pods that hold 2 ml of your favorite vape juice. These cartridges work with the Uwell Caliburn device and come in a pack of four (4) to keep you supplied with replacement pods while on the go or at home.


This product is a must have for those who purchased the Uwell Caliburn. These replacement pods fit into your current device to keep you supplied with more juice while on the go or at home. With 2ml of vape juice with a resistance of 0.6ohm. If you own a Uwell caliber or plan on buying one, this is a must have product.


*The Replacement Pod Cartridges come prefilled. Uwell does not recommend using any e-liquids other than what is included with this product. The use of other e-liquid may cause damage to your pod cartridge.*


How Do I Use Uwell Caliburn A2 Pods?


We recommend letting your vape juice fully dry out before adding any more or dissolving any excess e-liquid that could be left inside the coil chamber. To dissolve leftover e-juice currently in your pod cartridge, we recommend taking a small amount of warm water and dropping a few drops inside the coil chamber. Let the cartridge sit for a minute, dry it off and then fill it with your vape juice. Allow time to fully dry out before using again. This will prevent any unwanted flavors transferring into your next pod cartridge refill.


To use the Uwell Caliburn Replacement Pod Cartridges, simply follow these steps:

Step 1 - Remove the used pod cartridge from your device by gently pulling.

Step 2 - Insert a new filled pod cartridge into the device and slide in place until it clicks.


How Do I Recharge My Uwell Caliburn Using The USB Cable?


To recharge your Caliburn device, follow these simple steps:


Step 1 - Make sure that battery is turned off by pressing the power button 5 times in quick succession to ensure the device is powered down.

Step 2 - Connect the micro-USB end of the included USB cable to your Uwell Caliburn kit and connect the other end to a power source such as an AC wall charger or computer USB port.

Step 3 - The battery indicator light will blink while it is powering up and will turn solid in color once the device has been fully charged.


How Do I Operate My Uwell Caliburn?


To power on your Caliburn kit, click the fire button 5 times within 2 seconds to activate the device. To use temperature control mode, switch between modes by clicking the fire button 3 times quickly. The LED light next to the firing button will flash when entering temperature control mode and will remain lit when in use to indicate that you are vaping in temperature control mode.


You can charge your Uwell Caliburn pod system using a micro-USB charger by plugging the micro-USB end into your Caliburn vape pod device and then connecting the USB side to a wall adapter, power bank or PC. The indicator light will remain lit when plugged in and charging. If there are no indicators displayed when charging your device, please disconnect and try again. Once fully charged, the battery indicator will go out.


Where Can I Buy Uwell Caliburn A2 Pods?


Replacement Pod Cartridges for the Uwell Caliburn can be found at Raven Route. They hold up to 2ml of vape juice with a resistance of 0.6ohm which is compatible with other standard devices that accept the 510 threaded connection pattern. These replacement pods are prefilled with our signature Salt e-liquid to ensure the best flavors at the lowest prices.


For a limited time, you can purchase these four pack replacements for your Uwell Caliburn at a very reasonable price. This is almost 50 percent off their regular price at Raven Route.


Comentários

Não foi possível carregar comentários
Parece que houve um problema técnico. Tente reconectar ou atualizar a página.
bottom of page